Yamaha's whole AVR line — RX-A, RX-V, RX-S, TSR and HTR series — shares one control protocol: Yamaha Extended Control (YXC), an HTTP API under /YamahaExtendedControl/v1/ on port 80. That is why a single app entry covers the entire family instead of a per-model list.
Discovery is SSDP-based: the receiver's desc.xml must contain <manufacturer>Yamaha</manufacturer> and an X_yxcControlURL entry. Remote97 also probes port 80 (and 8081–8084 as fallback) to catch receivers that do not advertise reliably.
What you can control
- Power / standby and current power state.
- Volume in the receiver's own scale, plus mute and volume stepping.
- Input selection — HDMI, optical, coaxial, phono, Bluetooth, network sources.
- Sound programs and listening modes, plus tone / dialogue adjustments where the model exposes them.
- Zones — multi-zone models expose Zone 2 (and above) as separate controllable endpoints.
- Playback and scenes — transport keys for network sources and one-tap scene recall.
Set it up
Enable Network Standby on the receiver
This keeps the YXC endpoint alive while the unit appears off. Without it, the receiver will not answer after standby.
Install Remote97 and join the same LAN
Download from the download page.
Run discovery
SSDP finds the receiver and confirms the manufacturer tag; a direct port-80 probe is used as a fallback.
Or add the IP manually
Useful on managed switches or VLANs where multicast discovery is filtered.
Why this beats a cloud-based remote
YXC is a LAN protocol. Commands do not leave your router, response times are a few milliseconds, and the remote keeps working during an internet outage. There is no account to create and no subscription for "premium" volume buttons. See why local IP control beats cloud hubs for the longer explanation.
YNCA serial-over-IP style protocol on port 50000 is a different interface and is not used here. If a Yamaha device only answers on 50000, it will not appear as a YXC receiver.Troubleshooting
- Receiver disappears after standby: turn on Network Standby in the receiver's setup menu.
- Discovery shows a wrong device on port 80: Remote97 requires the Yamaha manufacturer tag before it classifies a device, precisely to avoid misidentifying arbitrary web servers.
- Multi-zone controls missing: zone controls only appear on models that report additional zones; the app reads capability from the device rather than assuming it.
- Slow or no response: check for a guest network, AP isolation, or a VPN app that hijacks the local route.
