Onkyo (and its Integra sibling) use ISCP / eISCP — Integra Serial Control Protocol wrapped for Ethernet — on TCP/UDP 60128. Each eISCP frame is a 16-byte header followed by an ASCII command such as MVLUP or SLI26. The receiver replies with the actual resulting state, which is why the app can show a real volume level rather than an optimistic guess.
What you can control
- Power — on / standby with state read back.
- Volume and mute — absolute level, step up/down, mute toggle.
- Input selection — the receiver's full selector list (HDMI, optical, phono, network, Bluetooth).
- Listening modes — stereo, Dolby / DTS variants and the receiver's own presets.
- Second zone — on models that support it, Zone 2 power/volume/source are separate commands.
Set it up
Enable Network Standby
On the receiver: Setup → Hardware / Network → Network Standby. The eISCP listener must survive standby.
Install Remote97 on the same LAN
Get it from the download page.
Discover or add the IP
Remote97 probes port 60128 across the selected subnet; manual IP add works too when multicast is filtered.
Use status feedback
Because eISCP answers with the resulting state, volume and input shown in the app stay in sync with the front panel.
Honest limitations and troubleshooting
- Not discovered: reserve a DHCP lease, or add the IP manually; check that no VPN app is stealing the local route.
- Commands time out: confirm the receiver's "Network Control" / "Control via IP" option is enabled.
- Inputs look wrong: the selector list is read from the receiver; re-open the device page after changing HDMI assignments.
