webOS TVs expose a local control interface called SSAP (Simple Service Access Protocol) on a WebSocket at TCP 3000. Remote97 opens that socket, sends a hello, completes a one-time pairing handshake, and then speaks JSON requests such as ssap://audio/setVolume and ssap://tv/switchInput. Nothing goes through a cloud service — the phone and the TV talk across your LAN.

What you can control

Once paired, the TV treats the app as a registered client:

Set it up in four steps

1

Install Remote97

Get it from the download page — Android, Windows and iOS are supported.

2

Join the same network

Phone and TV must be on the same LAN / VLAN. Guest WiFi and AP isolation will block discovery.

3

Let it discover, or add the IP manually

Remote97 probes port 3000 on local addresses. If the TV does not advertise itself, use manual add and type the TV's IP address.

4

Accept the pairing prompt on the TV

webOS shows a one-time consent dialog. Accept it and the pairing key stays on your device — no account is created.

The honest limitations

Power-on is the weak spot. When a webOS TV is fully off, its network stack usually sleeps, so a Wake-on-LAN style command is not reliable. Keep the physical remote handy for the first power-on, or enable the TV's quick-start / always-connected option if your model offers one.

Remote97 is a WiFi remote, not an infrared blaster: there is no line-of-sight requirement between devices, but the TV must be reachable on the network at the moment you send a command. It also cannot reach the TV from outside your home network — that is a deliberate consequence of the no-cloud design, not a missing feature.

Troubleshooting