Wake-on-LAN (WoL) is a standard way to turn on a computer over the local network. The device being woken stays in a low-power state with its network card listening. Another device on the LAN sends a small "magic packet" containing the target's MAC address, and the network card boots the machine. Remote97 turns that packet into a single wake button — and, unlike a lot of WoL tools, it drops the same action into your scenes and custom control panels.
What you can do
- One-tap wake — send a standard 102-byte magic packet (six
0xFFbytes followed by the target MAC repeated 16 times) over UDP ports 9 and 7. - Both broadcast forms — a subnet-directed broadcast (for iOS, which will not deliver
255.255.255.255) plus the global broadcast as a fallback. Highest cross-platform success rate. - Scenes — put "wake the HTPC" at the front of a Movie night scene, followed by power/input commands to the AVR and TV. See movie night scenes.
- Custom control panels — add a dedicated wake tile next to all your other device controls.
- Local, private — the packet goes from your phone straight over your LAN. No hub, no cloud relay, no account, and your MAC address is never uploaded.
An honest limit: no status readback
This matters in scenes. A wake action means "the packet was sent"; it does not guarantee the following commands will land instantly. A PC that is just powering on may take tens of seconds before its network services accept commands. Build a delay into the scene if the next step talks to the machine you just woke.
Set it up
Enable WoL on the target machine
In BIOS/UEFI turn on Wake on LAN / PCIe device wake and turn off ErP or Deep Sleep. In the OS, set the NIC's "Wake on Magic Packet" option to Enabled.
Use a wired connection
Plug in an Ethernet cable. WiFi almost never survives sleep/shutdown. A USB-to-Ethernet adapter only works if it stays powered in standby and its driver supports WoL — many do not.
Allow the NIC to wake the computer
On Windows, enable "Allow this device to wake the computer" (and "Only allow a magic packet") in the adapter's power-management settings, and disable Fast Startup — otherwise shutdown (S5) wake will not work.
Give it a stable IP
A DHCP reservation in your router keeps the target reachable. Make sure AP/client isolation is off and the phone is on the same subnet.
Add the device in Remote97
Install from the download page, add a "Network wake" device, and enter its MAC address using the six-box input (no colons needed). You can edit the MAC later in the device details; scenes and panels pick up the change automatically.
Troubleshooting: it still will not wake
- Nothing happens at all: confirm the machine can be woken by another WoL tool first — that isolates the PC's own settings from the app.
- Works from sleep, not from shutdown: almost always Fast Startup, ErP power saving, or a USB NIC that loses power in S5.
- Phone on WiFi, target on Ethernet: check that the router is not isolating wireless clients and that both are on the same subnet.
- Sleep works but shutdown does not: that is a hardware/BIOS limitation on many laptops, not an app bug.
- Need vendor-specific power commands instead: a serial-over-IP gateway or the device's own network protocol is the usual route.
